(tools not included, shown for reference only)
The rear side cutoff, multi-tool holder was designed to complement our four position, gang-tooling tool posts (P/N 5930 or P/N 5935). It can be used in conjunction with the gang-tooling tool post, or on its own for our customers who want to convert their Sherline lathe into a “Chucker Lathe” or gang-tooling lathe.
Our rear side cutoff, multi-tool holder offers a convenient and accurate way to hold up to two, round boring tools with a known centerline-to-centerline distance of 1.500″, and a slot for holding a cutoff tool blade (P/N 30860). This tool post has (2) 5/8″ holes for customers who want to use E-16 collet holders with a 5/8″ shank, and a slot to hold the cutoff tool blade with two locking screws for each tool.
For video instructions on “Indicating in Your Gang-Tooling Tool Post,” click here.
Includes the following:
- 5/8″ Rear Side Cutoff Multi-Tool Post Body
- 10-32 x 1″ SHC Screw (2)
- Extended Tool-Post T-Nut (2)
- 10-32 x 3/4″ SHC Screw (6)
- #10 Washer (4)
- Steel Dowel Pin 1/4″ x 3/4″ (2)
Tool Post Body Material - Aluminum
Body Coating - Black Anodized
Body Dimensions (H x W X D) - 1.7″ x 3.764″ x 1.1875″
Considerations Regarding this Tool Post and Its Possible End Uses
There are many considerations regarding this tool post and its possible end uses. Please check the instructions for a complete list (click on the Instructions below to download the document). This tool post is designed to be used with our 13″ Mill Table (P/N 50180 or P/N 67050) in place of the crosslide. Other recommended optional equipment includes P/N 1294 Riser Plate in order for your tools to be on centerline with the headstock spindle.
While the gang-tooling tool post will mount on the the 6″ and 8″ crosslides, its size renders it unusable on either of these crosslides.
Download PDF 5936 Instructions